keyboard-adapter
O1NEXT USB Keyboard Adapter — a modern USB keyboard on the Osborne 1's own connector
Status: reference design defined; spec validation pending.
Tracks #47 (split out of #45). Source: hardware/keyboard-adapter/.
Board register:
hardware/README.md.
What it is
A small RP2040 board that presents a USB-A port for any HID keyboard, and drives the Osborne 1’s own 8×8 keyboard matrix as if the original keys were being pressed. Plug in a keyboard, type, and the machine sees keystrokes — no BIOS change, no software, nothing cut.
How it attaches
The P4 keyboard connector on later “blue/grey” O1A machines: a coiled cable
with a 24-hole plug of which only the inner 20 pins mate. The documented pinout is
1 = GND, 2–9 = rows, 10–17 = columns, 18 = NC, 19 = +12 V, 20 = GND.
- Rows are watched as 5 V-tolerant inputs; columns are driven open-drain through a 74LVC07-class buffer, matching the stock 74LS05 stage, so the adapter can never fight the host.
- The matrix firmware is shared with the interposer’s web-KVM personality (#45), which pokes the same matrix.
Power, and why it no longer needs the case opened
There are three ways to feed it, and the third is the one to use:
- Variant A — internal. +12 V from P4 pin 19, which is wired through jumper J6 and a 22 Ω R21. J6 is factory-open, so this means opening the machine to bridge it.
- Variant B — external. Power from a USB hub or a 5 V feed on the upstream side, for a completely untouched machine.
- Variant C — from the MODEM port. The MODEM port (P1, DE-9 pin 7) carries the same +12 V through the same R21, and it is reachable from outside. A 9-pin passthrough from the adapter to the modem port takes power there. Nobody cracks the case.
One PCB serves all three through a power-source jumper. Both loads share R21 if the WiFi modem is also fitted — see External WiFi modem.
Still to confirm on a real machine
- The pinout against
research/osborne1/OCC1_1A2011-00_Schem_RevE.pdf, and a continuity check of rows vs columns, GND, and pin 19. - That rows really are driven low one-hot via open-collector inverters with the columns pulled up through a 3.3 K pack.
- The stock scan rate, to size the polling loop or PIO snoop.
- That P1 pin 7 is live without a J6-style bridge.