Status: concept; the directory exists and the spec is in it. No schematic
yet — #49 is the issue that produces one.
Tracks #49 (Phase 5). Source: hardware/next-integrated/. Board register:
hardware/README.md.
What it is
The SFF board — the foundation of the O1NEXT. A fully integrated board: everything the interposer does, designed in as firmware rather than plugged in.
It is not a 1:1 swap, and it does not try to be. This board can go into a real chassis or into any other design — up to the end user. Nothing about it is constrained by a 1982 footprint. (A 1:1 mainboard replacement, which would be constrained that way, is possible if a chassis ever needs restoring and is not planned — see Hardware that is not a board in the register.)
The O1NEXT is this board with the rest of the machine wrapped around it.
Why build it at all, if the interposer exists
Because they answer different questions:
- The interposer is the precursor: the same capability on a board that plugs into a real machine, and it keeps the upgrade path open for anyone who wants it.
- This board is the new machine. It can be smaller, cheaper, and faster than an Osborne 1 with an interposer in it, and it does not need a 40-year-old CPU socket to work.
What it adds over the original
- Turbo-capable — an 8 MHz clock, which is the “2× business turbo” the WiFi modem’s baud buffering exists to exploit.
- Onboard flash library, so it boots from internal storage with no card.
- USB-C PD power, shared with the complete O1NEXT.
- The interposer’s personalities as firmware, not as a second board.
The I/O complement
Deliberately not the original machine’s connector set: what is kept is kept because period hardware needs it, and what is dropped is dropped because a personality replaces it.
| Function | Connector | Note |
|---|---|---|
| Serial | DB-25 (P2) | The RS-232C port, 6850 ACIA-driven |
| IEEE-488 | Edge connector (P3) | The GPIB / Drive C bus |
| Keyboard | 24-position (P4) | So a real O1 keyboard can be used |
| Video | HDMI out | Adjacent to the RESET and TURBO buttons |
| Storage | SD / microSD slot | The bulk removable store |
| Expansion | USB-A #1 | Fixed function: memory expansion |
| Keyboard (USB) | USB-A #2 | Fixed function: the USB keyboard |
The two USB-A ports are fixed function on purpose — neither is a general-purpose host, so neither needs a hub, a driver stack or a negotiation story.
No composite. The board carries none of the analogue driver circuitry, so there is no composite output to offer at all — that discrete chain is an OEM mainboard’s job.
No MODEM port — but the modem is in. P1 is a TTL tap onto the same 6850 ACIA the RS-232 port uses, so the connector has nothing left to do; the modem personality is fundamental (the machine needs WiFi) and lives on the board. The DB-25 RS-232 port stays.
The display is an 8” 1024×768 HDMI panel inside, plus an external HDMI port: the RP2354B drives HDMI directly, and that panel size is available off the shelf.
What it keeps
Original ROMs and original software, unchanged. The whole project’s thesis is augmentation rather than replacement, and this board is the strictest test of it: if period software cannot tell it apart from an Osborne 1, it is finished.
Still to do
Everything, past the concept. The block diagram comes first, then connector placement for the complement above — and there is no footprint to inherit: the end user decides what this board goes into.